1-800-540-9051
Info@HomesteadSupplier.com
7am-4pm Pacific Time Mon-Fri
1-800-540-9051
Info@HomesteadSupplier.com
7am-4pm Pacific Time Mon-Fri
1-800-540-9051
Info@HomesteadSupplier.com
7am-4pm Pacific Time Mon-Fri
1-800-540-9051
Info@HomesteadSupplier.com
7am-4pm Pacific Time Mon-Fri
Stand inside your garage and open the door. Now look at the ceiling. Chances are, the door and its tracks take up much of the space above the opening. That can make it difficult to use the ceiling area for storage, a vehicle lift, or other equipment.
A high lift conversion changes how the door travels. By extending the vertical track, the door rises higher before turning toward the ceiling, creating more usable overhead clearance.
Below, we'll explain how the conversion works, which garages are suitable, and what you can expect to pay. We'll also cover opener compatibility and safety, since both are important parts of planning the job.
Normally, a sectional garage door travels upward a short distance before curving back toward the ceiling. A high lift setup extends the vertical track, allowing the door to rise higher before making that turn. Before recommending this type of setup, a garage door service company in Orange County should measure the garage, since ceiling height, door weight, and available clearance all affect the design.
So, what extra space does it create? According to Up & Down Garage Doors, a high lift setup can provide around 12 to 15 inches of additional clearance, sometimes more. The actual amount depends on the garage layout and track configuration.
That extra room can make a difference if you have overhead storage, want to install a car lift, or need more clearance for taller vehicles like pickup trucks and vans. It can also make a garage workshop more practical by freeing up valuable overhead space.
Start by checking the ceiling height. Around 12 feet or higher can make a high lift installation easier, but shorter ceilings may still qualify depending on the garage layout. As a general guideline, Up & Down Garage Doors says you need roughly 12 inches of open space above the door opening.
You can also make a rough estimate yourself. Eden Coast, a garage door supplier, suggests subtracting 10 inches from your available headroom. That allowance accounts for the horizontal track, drums, and end bearings.
For example, if your garage ceiling is 12 feet high and your door is 8 feet tall, you have 48 inches of headroom. Subtract 10 inches, and you get up to 38 inches of potential additional lift. This is only a preliminary estimate. An installer still needs to check the actual measurements and hardware requirements.
Next, look at the door itself. Sectional doors made from steel, wood composite, or aluminum can often be converted, provided the panels are in good condition and the door is properly balanced.
A one-piece tilt-up door is different. It doesn't use the same sectional track arrangement, so it generally isn't suitable for a standard high lift conversion. You may need a different solution if you have this type of door.

The tracks get most of the attention, but they're only one part of the job. The installer modifies the track arrangement, adding the appropriate curved sections at the higher transition point so the door can travel farther up the wall.
The drums also need attention. High lift systems often use tapered drums designed to handle the longer cable travel. The cables and torsion springs may need to be replaced or adjusted to match the new arrangement.
Door weight matters here, too. Wood and glass doors can be heavier than standard steel doors, so the spring rate needs to be calculated according to the actual weight of the door.
Once the tracks, drums, cables, and springs are properly matched, the door should move smoothly and remain balanced. This also helps prevent unnecessary strain on the opener.
Garage door springs store a significant amount of tension. Even companies selling high lift kits for home installation warn that the work can be dangerous.
If a spring is set incorrectly, the door may become unbalanced or move unevenly. A cable can also slip off its drum during operation, creating a serious safety risk.
A trained technician measures the door, checks its weight and balance, and selects the appropriate springs and hardware for the new track arrangement. The cables and drums must also be aligned correctly to ensure smooth operation.
Most single-door conversions can be completed in one visit. Blue Sky Garage Doors estimates that a typical single-door installation takes around four to six hours, although the actual time depends on the garage and the work involved.
High lift garage door conversions typically cost between $2,500 and $4,000, depending on the setup and installation requirements. Where your project falls within that range depends on several factors, including door size, ceiling height, spring configuration, and whether the existing opener can work with the new track layout.
Have two garage doors? Expect a higher total, since each opening needs its own track configuration and hardware. Adding a new door or opener will increase the cost further.
Before agreeing to the work, ask for a written estimate that breaks down the installation, hardware, spring adjustments, and any opener replacement. Make sure you understand what's included and whether additional work could affect the final price.
Getting those details upfront makes it easier to compare quotes and avoid unexpected costs on installation day.

Here's where people can run into problems. A chain or belt opener mounted to the ceiling may interfere with the raised track, depending on the garage layout. That's why many installers recommend a wall-mounted jackshaft opener, which keeps the ceiling clear and can work better with certain high lift configurations.
The opener needs to be selected alongside the new track layout, making it an important part of any high lift garage door conversion. The right choice depends on the door's design, available side clearance, and the hardware used in the conversion.
It's also worth considering the age of your existing opener. Many garage door openers last around 10 to 15 years, although usage and maintenance can affect their lifespan. If yours is approaching that range, replacing it during the conversion could save you the cost and hassle of arranging another service visit later.
A high lift conversion can make better use of the space above your garage door, whether you need room for a vehicle lift, taller vehicles, overhead storage, or a workshop.
Start by measuring your available headroom and checking what type of garage door you have. Then have a qualified installer assess the track arrangement, spring requirements, and opener compatibility before recommending a setup.
Ask for a detailed estimate before work begins, and make sure the installer explains what needs to change. With the right measurements and hardware, you can get the extra clearance without compromising the door's balance or safe operation.
Garage Door Dr. is a garage door installation and repair company based in Orange County, CA. Established in 2021, the company provides residential and commercial garage door services, including garage door repair, spring replacement, opener repair, emergency repairs, high lift conversions, new installations, and garage door replacements.
Its services cover torsion spring systems, belt- and chain-drive openers, sectional steel doors, and high lift garage door systems. Garage Door Dr. serves Dana Point, Aliso Viejo, Lake Forest, Mission Viejo, and San Clemente, with a focus on dependable workmanship, professional service, and consistent results.
Compare products
{"one"=>"Select 2 or 3 items to compare", "other"=>"{{ count }} of 3 items selected"}
Leave a comment